Say Goodbye to Clogging and Ink Leakage: the Ultimate Solution for Adjusting the Nozzle and Ink Stack Cap

🔥  Some channel is not displayed when the test strip is printed.

🔥  First of all, the nozzle for cleaning printing, if there is no improvement to check whether the nozzle and ink stack cap alignment

🔥  You can see the obvious misalignment here

🔥  Here needs to enter the manufacturer mode to adjust the trolley

🔥  CTRL+F12 goes into manufacturer mode.

🔥  Password:222222

🔥  Modify hit limit back to zero distance;(The 100 Pulse X motor moves 0.79mm)

🔥  When the value increases, the initial position of the carriage shifts to the left; when the value decreases, the initial position of the carriage shifts to the right.

🔥  Save and load after modifying the value.

🔥  Restart the device and software after completion, the settings take effect.

🔥  After adjusting the values, the display is aligned.

🔥  Re-print the nozzle test, the test strip is perfect.