Complete Guide to Modifying Automatic Moisturizing Function Parameters

1. Preparations: First, set the cleaning or moisturizing time at the arrow mark and save the settings after completion;

2. Enter Factory Mode: Open advanced settings, enter factory mode via the shortcut key Ctrl+H+F12, and enter the password 222222 to complete verification;

3. Adjust Ink Pumping Parameters:

◦ Enter the software background and click "Manual Clean" → "Pumping Ink Param" → "Clean Strong" in sequence;

◦ Locate the "Pumping Ink Take Time" parameter, with a default setting range of 5000-6000 milliseconds;

◦ If the moisturizer injected into the ink cap overflows too much, reduce the "Pumping Ink Take Time"; if the moisturizer is insufficient, increase the parameter;

4. Take Effect: Save the settings after modification, and the parameters will take effect immediately. You can fine-tune again according to the actual effect to achieve the best state.